Direct Replacement for Original Part #: 028 903 030 A  / 038 903 024 F

14V, 120A

NOTE: You will be charged a core deposit that will be refunded upon receipt of your old alternator. Alternatively you may send your alternator prior to ordering and in that case a core charge will not apply

Direct Replacement for Original Part #:
038 903 023 L
038 903 023 N
038 903 023 R
038 903 024 A
038 903 024 E

14V, 90A

NOTE: You will be charged a core deposit that will be refunded upon receipt of your old alternator. Alternatively you may send your alternator prior to ordering and in that case a core charge will not apply.

Direct Replacement for Original Part #:
038903018P
038903018PX
038903024D


14V, 90A

NOTE: You will be charged a core deposit that will be refunded upon receipt of your old alternator. Alternatively you may send your alternator prior to ordering and in that case a core charge will not apply.

May be used to fasten the water pump

Corresponds to the original VW part number N90221803

Models:
Golf 1998 >, Bora/Jetta IV 1999 >, Passat 1997 >, Eos 2006>,
Sharan 1996 >, Touareg 2003 >, Phaeton 2003 >,
Transporter 1991 >, T5 6-Zyl. 2004>, A3 6-Zyl. 2004 >,
A8 1994 >, Audi TT 1999 >

Engines:
6-Cyl. fuel-injected (4-Valve), 8-Cyl. fuel-injected (W8), 12-Cyl. fuel-injected (W12).

Used to lock camshafts during removal and installation.

Part #: T10068A (supercedes old part # T10068)

This bolt is utliized for fastening either the timing chain sprocket or camshaft on the following engines: V5, V6, VR6, R32.

Corresponds to the original VW part number N10203803

Flushes out and cleans the engine from the inside. Highly effective cleaning additive dissolves sludge and lacquer formers, coats solid particles and liquid contaminants. These are drained with the used oil during the oil change. After carrying out this type of prepared oil change, the fresh oil is able to realize its full performance potential: ˜ The engine develops its full performance again ˜ Runs with less wear ˜ Exhaust gas properties are optimised ˜ Deficient lubrication is minimized.

Operational area: Add to the engine oil BEFORE the oil change. After approx. 10 minutes idling, drain used oil, change the filter and fill with fresh oil. 500 ml is sufficient for engines holding up to 5 litres of oil.

Fits all R32's with engine codes BML or BFH

Corresponds to the original VW part number 022103383M

This nut is primarily used for the installation of exhaust headers

Corresponds to the original VW part number N90085001

Click for application guide

4-Wire

Direct replacement for part #: 022906262L