Drain Plug Washer A14 x 20

Corresponds to the original VW part number N0138492

2.0L Throttle Body - 2E Engine found on Golf / Corrado / Vento equipped with automatic transmissions

Corresponds to the original VW part number 037133061AA

This washer is primarily used for the installation of exhaust headers

Corresponds to the original VW part number N90095501

Fits all engine codes PG, 2E & ADY (Corrado G60 & 2.0L)

Corresponds to the original VW part number 049109111C

May be used to fasten the water pump

Corresponds to the original VW part number N90221803

Corresponds to the original VW part number N90544202 or N90544203

Used to fasten the crank pulley/harmonic balancer on the crankshaft for the VR6

Corresponds to the original VW part numbers N0100873 and N0100875

Compatible with virtually all VW and Audi engines

Please note thaqt you wil require the following number of bolts depending on your application:

- Corrado, Golf III, Passat, Vento, Sharan, T4 VR6 Motor  - 26 Bolts

- Corrado, Golf, Passat G60, 2.0l, 2.0l 16V - 20 Bolts

Corresponds to the original VW part number N90008401

Fits VW Corrado, Golf, Passat B3 and Jetta II

Corresponds to the original VW part number 037103493K

Fits the following transmissions (check the top of your transmission for applicable code)

AGC, ATB, ATA, AYK, AYN, AYL, CBA, CCM, CAW, AGK, CES, CGY, CHN and CGP

Corresponds to the original VW part number 02A398001

This nut is primarily used for the installation of exhaust headers

Corresponds to the original VW part number N90085001

Fits most VW models

Corresponds to the original VW part number N90288901

Fits Passat (excluding Syncro), Golf II and Corrado.

Set includes front, right rear and left rear mounts. Replace them all at the same time and save yourself money!

Corresponds to the original part number 1H0253115C

Fits all models/years

Bestellmenge ist je Meter

Sehr stabiler Schlauch ideal für das Unterdrucksystem. Er wird normal als Kraftstoffschlauch verwendet, daruch ist eine besondere Haltbarkeit gegeben. Es wird empfohlen das Unterdrucksystem komplett auf diesen Schlauch umzurüsten, damit eine aufrechte Druckstabilität gewärhrleistet wird.

Includes piston rings and connecting rod bushing.

Includes piston rings and connecting rod bushing.

Flushes out and cleans the engine from the inside. Highly effective cleaning additive dissolves sludge and lacquer formers, coats solid particles and liquid contaminants. These are drained with the used oil during the oil change. After carrying out this type of prepared oil change, the fresh oil is able to realize its full performance potential: ˜ The engine develops its full performance again ˜ Runs with less wear ˜ Exhaust gas properties are optimised ˜ Deficient lubrication is minimized.

Operational area: Add to the engine oil BEFORE the oil change. After approx. 10 minutes idling, drain used oil, change the filter and fill with fresh oil. 500 ml is sufficient for engines holding up to 5 litres of oil.